Meagan and Louis Marton's 95 Tahoe.  Lowered and some of the basic sheetmetal mods complete.

Meagan's Tahoe after initial 4-4 drop.  This is just the start of a pretty major projects.  This Tahoe is scheduled for bags and a stock floor bodydrop.		Louis working on the rear drop.  These trucks can't go much more than 4 inches without major restructuring in the rear.		Setting up to shave factory lights and install Cadillac lights.
New Sir Michaels rollpan installed and waiting for final welding.	Filler pieces just about ready for grinding.  These pieces are very difficult to put in because of the imperfect fit they come with.  Usually a bit of cutting, grinding and welding is necessary to get them fit in the opening.			Grinding down all the welds.
Marked out for Cadillac lights.  Make sure to get these plumb and not leaning in or out.	New pieces tacked into place. A lot of fitting takes place at this stage to make sure the lights fit in correctly.	Louis welding up the light buckets and trial fitting the Cadillac pieces.